SYSTEM OVERVIEW
System overview: "HTR07-1U AVR Series line-interactive 1U rack/tower UPS protects connected equipment from blackouts, brownouts, surges and EMI/RFI line noise. Maintains AC output during blackouts and continuously corrects brownouts and overvoltages from 83V to 147V back to usable levels. Supports enhanced monitoring of UPS and line power conditions via built-in USB and DB9 ports, included PowerAlert monitoring software and complete cabling. Includes slot for SNMPWEBCARD accessory. Two single-outlet load management banks offer remote reboot of selected loads via software interface or automated load shedding to extendbattery runtime for the most critical loads during blackouts. Supports 1U rackmount and upright tower form factors with included mounting hardware. "
Voltage compatibility: 120 VAC
Frequency compatibility: 60 Hz
OUTPUT
Output volt amp capacity (VA): 750
Output watt capacity (watts): 450
Output nominal voltage: 120VAC sine wave output in AC and battery mode
Output voltage regulation: LINE MODE: Sine wave line voltage 120V (-21% +8%), BATTERY MODE: Sine wave output within 5% of 120VAC
Output frequency regulation: LINE MODE: Passes line frequency of 60Hz +/-10% BATTERY MODE: Inverter output regulated to 60Hz +/-0.5Hz
Outlet quantity / type: 6 x NEMA 5-15R
Customized load management receptacles: "2 single-outlet load banks that support automated load shedding and remote reboot on demand of locked network devices. Configurable via PowerAlert software to automatically switch off optional loads, like monitors, to increase available runtime for servers and other critical devices. "
Overload protection: 15A input breaker
INPUT
Maximum input amps: 7A
Input connection type: NEMA 5-15P
Input cord length: 10 ft., 14 gauge
Recommended electrical service: 15A 120V
BATTERY
Full load runtime: 7 min. (450 watts)
Half load runtime: 24 min. (225 watts)
DC system voltage: 24 VDC
Typical battery lifespan: 3-6 years, depending on usage
Battery recharge rate: 2-4 hours to 90%
Replacement Battery Cartridge: RBC64-1U
VOLTAGE REGULATION
Voltage regulation description: Line-interactive voltage regulation system corrects input voltages between 83 and 147 back to usable 120V nominal levels.
Overvoltage correction: Input voltages between 128V and 147V are reduced by 12%
Brownout correction: Input voltages between 83V and 107V are boosted by 14%
LEDS ALARMS & SWITCHES
Front panel LEDs: 5 front panel LEDs - Green POWER LED, 3 color BATTERY CHARGE LED, 3 color OUTPUT LOAD LEVEL LED, red BATTERY WARNING LED.
Alarms: 3-function audible alarm indicates power failure conditions (4 short beeps every 10 seconds), overload (continuous short beeps) and low battery (continuous tone)
Switches: 2 front panel mounted push-button switches for system enable, self-test and alarm cancel functions
SURGE / NOISE SUPPRESSION
AC surge suppression: 480 joules
AC suppression response time: Instantaneous
EMI / RFI AC noise suppression: Yes
PHYSICAL
Shipping weight (lbs): 34
Shipping weight (kg): 15.4
Unit weight (lbs): 30
Unit weight (kg): 13.6
Unit Dimensions (HWD/in): 1.75 x 17.5 x 16.75
Unit Dimensions (HWD/cm): 4.45 x 44.5 x 42.5
Shipping Dimensions (HWD/in): 6.25 x 23.5 x 22.5
Shipping Dimensions (HWD/cm): 15.9 x 60 x 57.2
Material of construction: Steel
Form factors supported: Supports 1U rackmount installation in 2- or 4-post racks; rackmount flanges are reconfigurable to support upright tower placement
Cooling method: Built-in cooling fan
Battery Access: Battery access door allows hot swap battery replacement without powering connected equipment off
ENVIRONMENTAL
Operating Temperature: +32 to +104 degrees Fahrenheit; 0 to +40 degrees Celsius
Storage Temperature: +5 to +122 degrees Fahrenheit; -15 to +50 degrees Celsius
Relative Humidity: 0 to 95%, non-condensing
Line mode BTU/hr. (Max.): 39.2
Battery mode BTU/hr. (Max.): 133.0
COMMUNICATIONS
Network monitoring port: 2 built-in monitoring ports, 1 USB and 1 DB9. Each supports on battery, low battery, power restored, AC line voltage, DC battery voltage, load percentage, battery charge current, battery capacity, internal UPS temperature and line frequency status messag
Software and cabling included: PowerAlert UPS monitoring software for network and stand-alone operating systems; ships with complete USB and DB9 cabling.
SNMP compatibility: Built-in accessory slot accommodates internal SNMP / Web card and other network accessories
WatchDog compatibility: Compatible with Tripp Lite's Watchdog Software to restore operation to locked equipment through soft reboot of application / OS or hard power off/on reboot of connected equipment—ideal for unattended kiosk applications
LINE / BATTERY TRANSFER
Transfer time from line power to battery mode: 2-4 milliseconds
Low voltage transfer to battery power: 83V (resets to line power as line voltage increases to 87V or higher)
High voltage transfer to battery power: 147V (resets to line power as line voltage decreases to 143V or lower)
CERTIFICATIONS
Certifications: Tested to UL1778 (USA), Tested to CSA (Canada), Class A (emissions), NOM (Mexico)
WARRANTY
Product warranty: 2 years
Connected equipment insurance (USA and Canada Only): $250,000
Optional coverage: 3-year, 5-year, next-day and on-site warranty coverage available for select opportunities
SPECIAL FEATURES
EPO port: EPO (Emergency Power Off) port and cable
TVSS grounding: Back panel grounding point with thumbscrew for dataline surge suppressors and other network accessories requiring a safe grounding point
Cold Start: Yes, inverter can be cold started to enable temporary AC output during a power failure
Appearance: Attractive all-black color scheme